Brass Road Disc Wheel Floor Pump Adaptor Fits Presta valves only Supplied with 2 spare O'ring seals Fits directly into pump hose
Brake Straddle Wire Carrier Yoke for cantilever and centre pull brakes.
Black Stainless steel square bladed butted straight pull spoke for this 2010+ rear wheel
Domed bottom bracket axle bolt that fits on the outside of most BMX cranks that use an 8 spline axle.
Domed bottom bracket axle bolt that fits on the outside of most BMX cranks that use an 8 spline axle.
Blazer Pro Scooter Pegs Anodized Gold 21mm diameter Length 51mm PLEASE NOTE: THESE DO NOT FIT ALL SCOOTERS. YOU NEED AT LEASE 11mm FROM THE CENTRE OF THE WHEEL AXLE TO THE UNDER SIDE OF YOUR SCOOTER DECK.
Set of 3 plastic spring clip fasteners to hold either brake cable or hydraulic hose to frame mounts.
Set of 3 plastic spring clip sleeves to hold either brake cable or hydraulic hose to frame mounts.
WELDTITE Packaged Loose Hardened Steel Ball Bearings with grease Available in 2 sizes: Smallest to Biggest: 3/16 Often used in front hubs and old skool BMX headset (4.76mm) 1/4 Often used in open ball bottom brackets and rear hubs (6.35mm)
WELDTITE Bagged 2 Caged Hardened Steel Ball Bearings Races Available in 2 options: 5/32 caged bearings for a traditional 1 inch headset (CAGE I.D 31mm - O.D 37mm) 3/16 caged bearings for a traditional BMX & old school MTB 1 inch headset (CAGE I.D 31mm - O.D 39.8mm) PLEASE REMEMBER WHEN FITTING CAGED BALL BEARINGS THE BEARINGS FACE INTO THE CUPS NOT THE CAGE.
WELDTITE Packed Caged Hardened Steel Ball Bearings Races Available in 2 options: 1/4 caged bearings for traditional cupped bottom brackets (CAGE I.D 19mm - O.D 29mm) Supplied with grease 5/16 caged bearings for 1 piece cranked BMX & MTB bottom brackets (CAGE I.D 32mm - O.D 44.5mm) Supplied with grease [this bottom bracket is often referred to as American Sized Bottom Bracket] PLEASE REMEMBER WHEN FITTING CAGED BALL BEARINGS THE BEARINGS FACE INTO THE CUPS NOT THE CAGE.
WELDTITE Bagged Loose Hardened Steel Ball Bearings Available in 5 sizes: Smallest to Biggest: 1/8 Often used in pedals, freewheels and very old floating cupped headsets. (3.18mm) 5/32 Often used in 1 inch & 1 1/8 open ball bearing headsets (3.97mm) 3/16 Often used in front hubs and old skool BMX headset (4.76mm) 7/32 Often used in Campagnolo & Plessier hubs (5.56mm) 1/4 Often used in open ball bottom brackets and rear hubs (6.35mm)
